Glastron SL262 can the deck be separated from the hull

[FiberglassFanatic]

Many Glastron models, like the SL262, come with a two-piece design where the deck is attached to the hull. Usually, there's aluminum trim around the edges that hides this joint. If you take off the trim and the fasteners, you might be able to pull the deck away from the hull, which could make it easier to get to any structural repairs. Just keep in mind that the joint might also be secured with adhesives, so you'll need to cut carefully to separate them. Before you dive in, it's a good idea to check your model's documentation or reach out to Glastron for specific advice

 

[Raybo01]

Many Glastron models, including the SL262, have a two-piece deck and hull joined with aluminum trim and adhesives, so removing trim and fasteners can help access repairs but requires careful cutting

 

[Surreaal]

Have you checked if the adhesive used on your specific Glastron model requires special tools or solvents for safe removal without damaging the deck or hull?

 

[flesh and stone]

What tools should I use in removing the trim and adhesives? anything in particular?

 

[trim&go]

I remember doing something similar a while ago on an old Checkmate boat. The trim popped off without much trouble, but that adhesive was a nightmare. I had to use a heat gun and some plastic scrapers to keep from scratching the glass. It took a while, but it really helped preserve the gelcoat.